Pilaster 1.20.301
€182.10
Specifications
| Material | Polyurethane foam |
|---|---|
| Height | 2690 mm |
| Width | 232 mm |
| Depth | 68 mm |
| Use | Interior |
| Finish | White, ready to paint |
| Moisture resistant | Yes |
A flat pilaster, 2690 mm tall, 232 mm wide and only 68 mm deep, so it sits close to the wall and suits rooms where a full or half column would take up too much space. It has a Corinthian pilaster capital with acanthus leaves and corner volutes over a fluted shaft, finished at the foot with a tall plinth with a moulded top. The set is made up of Capital 1.21.001, Shaft 1.22.010 and Base 1.23.100, and each part is also sold on its own. Check the overall height against your ceiling before ordering; the shaft is the part to trim if you need it shorter.
Every part is polyurethane foam: light enough to lift into place by hand, moisture resistant and delivered white, ready to paint. Bond the joints between the parts with Joint Adhesive 290ml (G07.S.290) (or Joint Adhesive 60ml (G08.S.60) for smaller jobs) and fix it in position with Multipurpose Adhesive 290ml (G10.U.290). Like all polyurethane decor it is decorative rather than structural: it cannot carry a ceiling, beam or any other load, so it must never stand in for a real column or post.
Component Parts
Adhesive For Mounting
Frequently Asked Questions
Find clear answers to common questions about Gaudi Coving products, installation, delivery, and ordering to help you choose the right coving and decorative mouldings with confidence.





















